Electro-voice EVID User Manual download pdf (Page 10)

INSTALLATION NOTE: MOUNTING TABS

For each attachment screw, first turn one half-

turn counterclockwise to release the mounting

tab from its guide.

Step 6: Connect an Auxiliary

Support Line (Figure 18)

Note the support ring on the back of the speak-

er.The ring allows for connection to a inde-

pendent and secure anchor point. Construction

codes often require the use of this secondary

support point.

Step 7: Adjust Tap Selector

(Figure 19)

The tap selector switch is located on the front

baffle.Adjust the speaker to the appropriate tap

setting before installing the grille. In some

70V/100V constant voltage installations it is

advisable to leave the grilles off if final speaker

audio level balance adjustments are to be made

later.After the levels are adjusted the grilles can

then be installed.

EVID™ C4.2, C8.2 and C8.2LP

In addition to the 8-ohm setting, the power taps are

30 W, 15 W, 7.5 W, and 3.7 W at both 70.7V and

100V, with a 1.8 W tap for 70.7V only.

EVID™ C8.2HC and C10.1

In addition to the 8-ohm setting, the power taps

are 60 W, 30 W, and 15 W at both 70.7V and

100V, with a 7.5 W tap for 70.7V only.

Step 8: Attach the Grille (Figure 20)

INSTALLATION NOTE:

GRILLE SAFETY FEATURE

EVID grilles features a unique safety tether to

prevent the grille from falling if the grille is

removed or comes loose after installation.

First, install the grille’s safety tether by push-

ing the grille fastener into the hole in the front

of the baffle (see Figure 20). Second, press the

grille into place until the front of the grille is

flush with the rim of the baffle. Make sure the

grille is securely seated to prevent it from

vibrating loose.

If you need to remove the grille, the easiest

way is to insert two bent paper clips or other

pointed objects into holes in the grille, then

apply slow even pressure to pull down on the

grille until that section of the grille comes out

slightly. Continue the same procedure around

the perimeter of the grille, loosening a portion at

a time until the grille is removed.

8 EVID™ Ceiling Series Installation and Operation Manual

Installation and Wiring

Figure 18: Attach auxiliary support line

Figure 19: Adjust tap selector (left:

C4.2/C8.2/C8.2LP; right: C10.1/C8.2HC)

Figure 20: Attach the grille

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Electro-voice EVID User Manual Page 10

Comments to this Manuals

Related products and manuals for Microphones Electro-voice EVID