Electro-voice N/D868 User Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 9/2003
Part Number 38109-827 Rev. B
N/D868 Part Number: 6682819
Polar Response:
Frequency Response:
(5 dB per division)
1000 Hz
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/553-5992 or 402/467-5321
For technical assistance, contact Technical Support at:
800/392-3497 or 952/736-4656
Specifications subject to change without notice.
Standard Placement & Use Guidelines
1. Always point the microphone at the desired source of sound, and away from any unwanted sources.
2.The microphone should be located close to the sound source to minimize interference from other potential sound sources.
3. Use the 3-to-1 rule when using multiple microphones. Place each microphone three times farther from other microphones as from the
desired sound source.
4. Minimize over-handling of the microphone to reduce unwanted mechanical noise.
5.Working close to the microphone will increase the bass tone and also provide increased gain-before-feedback.
Microphone Use and Placement
Please note that micing techniques are a matter of personal preference. These are merely guidelines to assist in the placement of the
microphone to gain optimal performance.
Usage Optimal Placement
Kick Drum Remove drum head and damp with a pillow or blanket. Position the mic on the
pillow or blanket a few inches in front of the drum beater. As an alternative,
position the mic on a small boom stand with the mic extended into the drum
and at a 90° angle to the drum beater.
Page view 1
1 2

Comments to this Manuals

No comments