Electro-Voice 301047-002 Owner's Manual

Owner's Manual

8EVID Owner’s ManualStep-by-Step Installationand Wiring (12.1 Subwoofer)Step 1: Mount the BracketThe mounting bracket can be installed twoways (see Fi

Step 4: Mount the Speaker to the BracketFirst remove the two Phillips-head screwson the rear of the enclosure. Use the sup-plied eyebolt to mount one

Mounting through a suspended ceiling gridOn the rear of the enclosure install andtighten two 3/8-16-thread forged steel eye-bolts (one is included) wi

Electro-Voice®products are guaranteedagainst malfunction due to defects in mate-rials or workmanship for a specified period,as noted in the individual

Installation ExamplesThe EVID™ Series is a product family withthe flexibility to fit the requirements ofmany different applications. Listed beloware s

The 12.1 subwoofer is a painted woodenclosure which can easily be repainted.Painting Process (3.2, 4.2, 6.2)The EVID™ 3.2, 4.2 and 6.2 are made ofhigh

14 EVID Owner’s ManualProblem Possible Cause(s) Action1. No sound Amplifier Connect a known working test speaker to the amplifieroutputs. If there is

15EVid Owner’s ManualU.S.A. and Canada only.For customer orders, contact the Customer Service department at800/392-3497 Fax: 800/955-6831For warranty

Table of Contents . . . . . . . . . . . . . . . . . iiProduct Description . . . . . . . . . . . . . . . 1Welcome . . . . . . . . . . . . . . . . . . .

WelcomeThank you for purchasing EVID™ Seriesloudspeakers. Read through this manual tofamiliarize yourself with the features,applications, and precauti

Model SummaryEVID™ 3.2Most compact of the EVID™ Series, theEVID™ 3.2 uses dual 3.5-inch LF driverswith a .75-inch titanium direct radiatortweeter to p

EVID™ Product Family8-Ohm ImpedancePart Number Model Description70-Volt/100-Volt-Equipped UnitsPart Number Model DescriptionSubwoofersPart Number Mode

4 EVID Owner’s ManualSAM™ (Strong-Arm-Mount™)SystemEVID™’s SAM™ system (Strong-Arm-Mount™) excels at meeting the four require-ments for mounting FGM/B

Step 2: Select Voltage Tap (Models4.2t and 6.2t Only)Before mounting the speaker to the brack-et, select the proper voltage tap setting foryour instal

Attach both logo caps as shown in Figure11 after tightening and securing the speaker.Step 4: Wire the SpeakerConnect the wires to the speaker at theba

7EVID Owner’s ManualPacking List (12.1 Subwoofer)Below is the list of parts included with theEVID™ 12.1 subwoofer. The parts are illus-trated in Figur