Electro-Voice UCC 1 Owner's Manual

Owner’s Manual UCC 1 USB-CAN CONVERTER

25 Baud Rate Bus Length 500 kbit/s 100 m 250 kbit/s 250 m 125 kbit/s 500 m 62,5 kbit/s 1000 m 20 kbit/s 2500 m 10 kbit/s 5000 m The use of re

26 Additionally, the length of any stub lines for participants that are not directly connected to the CAN-bus needs to be kept in mind. For data tran

27 7. Specifications CAN BUS: Sockets 2 x RJ-45 parallel (NEUTRIK EtherCon compatible) Baud Rate 500 / 250 / 125 / 62,5 / 20 / 10 kbit/s N

17 Contents 1. Description... 17

18 2. Controls and Connections Fig. 1: UCC1 front panel 1. USB connector This connector is for the connection to the USB-port on your PC. The int

19 3. Installation 3.1 Unpacking The UCC1 package includes the following parts: 1 UCC1 USB-CAN CONVERTER 1 Front panel 19“, 1HU 2 CAN-TERM 120 Ω CAN

20 4. Initial Operation Follow these four steps when operating the UCC1 for the first time: Connect the UCC1 to the PC and install the CAN drivers, i

21 Fig 4: System set-up with 5 amps and a single UCC1 / PC being the first unit on the bus Terminators at the UCC1 (first unit) and at the amp No.5

22 Fig 6: System with several racks and several UCC1 / PCs UCC1 anywhere on the CAN-bus Terminators at amp No. 10 (first unit) and amp No. 16 (las

23 The ISOLATED / GROUNDED switch located on the UCC1’s front panel allows bridging this galvanic isolation putting the CAN-bus of the UCC1 on circui

24 The pin-assignment of CAN-bus connectors is shown in figure 8. Fig. 8: CAN BUS IN / OUT connector pin-assignment 6.2 The CAN-Bus Standard Dev